Experimental validation of a model of an uncontrolled bicycle

In this paper, an experimental validation of some modelling aspects of an uncontrolled bicycle is presented. In numerical models, many physical aspects of the real bicycle are considered negligible, such as the flexibility of the frame and wheels, play in the bearings, and precise tire characteristics. The admissibility of these assumptions has been checked by comparing experimental results with numerical simulation results. The numerical simulations were performed on a three-degree-of-freedom benchmarked bicycle model. For the validation we considered the linearized equations of motion for small perturbations of the upright steady forward motion. The most dubious assumption that was validated in this model was the replacement of the tires by knife-edge wheels rolling without slipping (non-holonomic constraints). The experimental system consisted of an instrumented bicycle without rider. Sensors were present for measuring the roll rate, yaw rate, steering angle, and rear wheel rotation. Measurements were recorded for the case in which the bicycle coasted freely on a level surface. From these measured data, eigenvalues were extracted by means of curve fitting. These eigenvalues were then compared with the results from the linearized equations of motion of the model. As a result, the model appeared to be fairly accurate for the low-speed low-frequency behaviour.