Abstract
Machining of metal matrix composites (MMC) is a challenging process as they are difficult to cut and cutting tools get worn out in a short time. In this paper, the performance of two industrial carbide grades and a cubic boron nitride (CBN) tool are assessed when machining of AZ91/SiC composites. Mg-based composites with different volume fractions and particle sizes are machined at various cutting conditions to evaluate the tools wear resistance and finished surface. The surface of the worn-out tools and machined samples are analyzed by scanning electron microscope (SEM), energy-dispersive X-ray spectroscopy (EDS), and roughness tester. Results revealed that the tool wear increased for composites reinforced by smaller particles regardless of the tool type. Additionally, tool grade TH1000 resulted in longer tool life when machining of Mg-based composites compared to the CP500 grade so that at a cutting speed of 70 m/min and feed rate of 0.1 mm/rev, tool life improved nearly 250%. CBN tools showed the best performance when machining of Mg-based composites as tools became worn out after 255 s which is considerable compared to carbide tools. Also, the finished surface caused by cemented carbide CP500 indicated the worst quality.
Original language | English |
---|---|
Number of pages | 14 |
Journal | Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture |
DOIs | |
Publication status | Published - 2023 |
Bibliographical note
Green Open Access added to TU Delft Institutional Repository 'You share, we take care!' - Taverne project https://www.openaccess.nl/en/you-share-we-take-careOtherwise as indicated in the copyright section: the publisher is the copyright holder of this work and the author uses the Dutch legislation to make this work public.
Keywords
- cemented carbide
- cubic boron nitride
- machining
- Metal matric composites
- roughness
- wear